Home › Engine / Hybrid System › 2ZR-FXE (HYBRID / BATTERY CONTROL) › HV RELAY ASSEMBLY (for NICKEL METAL HYDRIDE BATTERY) › from 2019.09
RM32K0E _51 Engine / Hybrid System _083958 2ZR-FXE HYBRID / BATTERY CONTROL _0404385 HV RELAY ASSEMBLY(for NICKEL METAL HYDRIDE BATTERY) A

2ZR-FXE HYBRID / BATTERY CONTROL  HV RELAY ASSEMBLY(for NICKEL METAL HYDRIDE BATTERY)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the HV battery junction block assembly to the No. 1 hybrid battery shield sub-assembly with the 4 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If the HV battery junction block assembly has been struck or dropped, replace it with a new one.



b.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connectors are connected securely.



c.

Engage the 2 claws to install the wiring harness protector.


d.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connectors are connected securely.



e.

Engage the 2 claws to close the wiring harness protector.


f.

Engage the clamp.


g.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connectors are connected securely.



h.

Connect the electric vehicle battery plug assembly with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide G9230 8.INSTALL BATTERY COOLING BLOWER ASSEMBLY

Hide 76974F 11.INSTALL REAR UNDER SIDE COVER LH

Hide 67918A 12.INSTALL REAR DOOR SCUFF PLATE LH

Hide 76973F 13.INSTALL REAR UNDER SIDE COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 67917A 14.INSTALL REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.


Hide 72693 15.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 16.INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY