Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL HEADLIGHT ASSEMBLY
|
Install in this Direction |
Temporarily install the headlight assembly as shown in the illustration.
Install the headlight assembly with the bolt and 3 screws.
| *a | Connector Lock Lever |
|
Protective Tape |
|
Install in this Direction |
Connect the connector A.
Connect the connector B and raise the connector lock lever to engage the claw and lock the connector as shown in the illustration.
Remove the protective tape.
85319A
2.INSTALL INLET HOSE (for RH Side)
Install the inlet hose with the clip.
3.INSTALL FRONT BUMPER ASSEMBLY
4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for 2ZR-FXE:
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION
for M20A-FXS:
Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>INSTALLATION
5. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
6.PERFORM INITIALIZATION
7.ADJUST HEADLIGHT AIMING