Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
62180A
1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
When installing a curtain shield airbag assembly, have assistants hold it to prevent it from bending.
Check that the power switch off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Engage the hooks and claws (A) to temporarily install the curtain shield airbag assembly.
| *1 | Clip | *2 | Curtain Shield Airbag Clip Spacer |
| *a | Pin | *b | Claw (A) |
| *c | Claw (B) | *d | Spacer Location |
Install the 3 new bolts.
Do not twist the curtain shield airbag assembly when installing it.
Install the curtain shield airbag assembly with new spacer and new clip.
Engage the claws (B) to install each new clip.
Using needle nose pliers, push the pins into the clips.
Do not damage the pins.
Make sure that the pins of the clips are pushed in firmly.
| *a | Airbag Connector |
| *b | Airbag Connector Lock |
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock to install the airbag connector.
Securely lock the airbag connector lock.
2.INSTALL ROOF HEADLINING ASSEMBLY
3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for M20A-FXS:
Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>INSTALLATION
for 2ZR-FXE:
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION
4. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
5. PERFORM DIAGNOSTIC SYSTEM CHECK
6.INSPECT SRS WARNING LIGHT