Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
89170
1.INSTALL AIRBAG SENSOR ASSEMBLY
Check that the power switch off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Install the airbag sensor assembly with the 3 bolts.
If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag sensor assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.
When the power switch is first turned ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
|
Push in |
Connect the 3 connectors to the airbag sensor assembly as shown in the illustration.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Check that there is no looseness in the installed parts of the airbag sensor assembly.
Return the front floor carpet assembly and install the clip as shown in the illustration (for LH side).
Return the front floor carpet assembly and install the clip as shown in the illustration (for RH side).
87212F
2.INSTALL REAR NO. 2 AIR DUCT (w/ Rear Air Duct)
|
Install in this direction (1) |
|
Install in this direction (2) |
Engage the claws to install the rear No. 2 air duct as shown in the illustration.
3.INSTALL REAR CONSOLE BOX ASSEMBLY
4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for M20A-FXS:
Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>INSTALLATION
for 2ZR-FXE:
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION
5. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
6. PERFORM DIAGNOSTIC SYSTEM CHECK
7.INSPECT SRS WARNING LIGHT
8. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
When the airbag sensor assembly is replaced, perform zero point calibration.
Click here
The yaw rate and acceleration sensor is built into the airbag sensor assembly.