The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the floor side airbag sensor removal/installation are shown below.
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M20A-FXS:
Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>REMOVAL
for 2ZR-FXE:
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
73233
3.REMOVE LAP BELT OUTER ANCHOR COVER
73220
4.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
67914
5.REMOVE FRONT DOOR SCUFF PLATE
62312B
6.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Disconnect the front door opening trim weatherstrip to the extent that allows the removal of the center pillar lower garnish.
67918A
7.REMOVE REAR DOOR SCUFF PLATE
62332A
8.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Disconnect the rear door opening trim weatherstrip to the extent that allows the removal of the center pillar lower garnish.
62414A
9.REMOVE CENTER PILLAR LOWER GARNISH
89831E
10.REMOVE FLOOR SIDE AIRBAG SENSOR
Check that the power switch off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Remove the bolt and disengage the claw to separate the floor side airbag sensor.
Disconnect the connector to remove the floor side airbag sensor.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)
| *a | White Housing Lock | *b | Yellow CPA |
| *c | Connector lock is released | - | - |
Push down the white housing lock again and disconnect the connector.
Do not push down the part (A) shown in the illustration when disconnecting the connector.
Check that the position of the white housing lock is as shown in the illustration.
| *a | Incorrect | *b | Correct |