The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
53141F
1.REMOVE RADIATOR COVER
for GR SPORT:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for GR SPORT)>REMOVAL
except GR SPORT:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except GR SPORT)>REMOVAL
17751
2.REMOVE NO. 1 AIR CLEANER INLET
22030
3.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
25601
4.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY
89421
5.REMOVE E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)
23827D
6.REMOVE NO. 1 FUEL VAPOR FEED HOSE
Slide the hose clip and disconnect the No. 1 fuel vapor feed hose from the intake manifold.
Disengage the clamp to disconnect the No. 1 fuel vapor feed hose.
7.DISCONNECT ENGINE WIRE
Disconnect the fuel vapor feed hose from the No. 1 vacuum switching valve assembly.
Disconnect the 2 connectors.
Remove the 3 bolts and disconnect the engine wire from the fuel delivery guard, intake manifold and timing chain cover assembly.
Disengage the 3 clamps to disconnect the engine wire from the intake manifold and fuel vapor feed pipe.
Remove the bolt and disconnect the engine wire from the intake manifold.
Disengage the clamp to disconnect the engine wire from the intake manifold.
16279
8.DISCONNECT NO. 3 WATER BY-PASS PIPE
Slide the clip and disconnect the water by-pass hose from the No. 3 water by-pass pipe.
Using an 8 mm socket wrench, remove the bolt and disconnect the No. 3 water by-pass pipe from the intake manifold.
16264D
9.DISCONNECT NO. 2 WATER BY-PASS HOSE
Disengage the clamp to disconnect the No. 2 water by-pass hose from the No. 2 water hose clamp bracket.
10.REMOVE BRACKET
| *1 | Wire Harness Clamp Bracket |
| *2 | No. 2 Water Hose Clamp Bracket |
Using an 8 mm socket wrench, remove the bolt and wire harness clamp bracket from the intake manifold.
Remove the bolt and No. 2 water hose clamp bracket from the intake manifold.
17138B
11.REMOVE INTAKE MANIFOLD STAY
Disengage the clamp to disconnect the HV air conditioning wire from the No. 1 water hose clamp bracket.
Using an 8 mm socket wrench, remove the bolt (A).
Remove the bolt (B).
Disengage the guide to remove the intake manifold stay.
17111
12.REMOVE INTAKE MANIFOLD
Remove the 4 bolts, 2 nuts, No. 2 fuel delivery guard and intake manifold from the cylinder head sub-assembly.
17177
13.REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET
Remove the No. 1 intake manifold to head gasket from the intake manifold.
14.REMOVE VACUUM HOSE
Remove the vacuum hose from the intake manifold.