Home › Engine / Hybrid System › STOP AND START › ENGINE STOP AND START ECU › 2016.10–2019.09
RM32H0E _51 Engine / Hybrid System _059427 STOP AND START _0290844 ENGINE STOP AND START ECU A

STOP AND START  ENGINE STOP AND START ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine stop and start ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision syatem
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Replacement of engine stop and start ECU
1.

Upload the number of starter operations

2.

Reset air conditioning information

3.

Learning of air conditioning information

4.

Clear the zero point calibration data

5.

Perform zero point calibration of the deceleration sensor


Stop and start system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2. READ NUMBER OF STARTER OPERATIONS

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>REMOVAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 82877 4.REMOVE ECU INTEGRATION BOX RH (for LHD)

Hide 82878 5.REMOVE ECU INTEGRATION BOX LH (for RHD)

Hide 89261A 6.REMOVE ENGINE STOP AND START ECU (for LHD)

A387504

a.

Disengage the 2 claws and remove the engine stop and start ECU from the ECU integration box RH.


Hide 89261A 7.REMOVE ENGINE STOP AND START ECU (for RHD)

a.
A387506

Disengage the 2 claws and remove the engine stop and start ECU from the ECU integration box LH.