Home › Engine / Hybrid System › 8NR-FTS (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL
RM32H0E _51 Engine / Hybrid System _059498 8NR-FTS ENGINE MECHANICAL _0291515 FRONT CRANKSHAFT OIL SEAL A

8NR-FTS ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11302A 1.INSTALL TIMING CHAIN COVER OIL SEAL

a.

Apply MP grease to the lip of a new timing chain cover oil seal.

NOTICE:

Keep the lip free from foreign matter.



b.
A351482C02
2.313,2.448 2.719,3.104 2.719,3.104 2.719,1.219 true 2.854,0.073 3.167,0.229 0.313,0.156 10 false *a 2.615,3.156 3.073,3.354 0.458,0.198 10 true SST
*a Tap in depth


Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover assembly edge.

SST
09223-22010  

Timing Chain Oil Seal Tap in Depth:

- 0.5 to 0.5 mm (- 0.0197 to 0.0197 in.)


NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap in the timing chain cover oil seal at an angle.




Hide 13470 2.INSTALL CRANKSHAFT PULLEY ASSEMBLY

a.
A352674C02
0.469,3.26 0.979,3.26 true 1.719,3.26 2.229,3.26 true 0.438,0.406 2.427,0.333 2.427,0.333 1.917,1.896 true 1.5,1.635 2.406,0.344 false 0.281,3.177 0.594,3.333 0.313,0.156 10 false *a 2.281,3.198 2.594,3.354 0.313,0.156 10 false *b 2.51,0.26 2.969,0.458 0.458,0.198 10 false SST
*a Hold
*b Turn


Using SST, hold the crankshaft pulley assembly in place and tighten the crankshaft pulley set bolt.

SST
09213-70011  (09213-70020)
09330-00021  

Torque:
180 N*m (1835 kgf*cm, 133 ft.*lbf)


Hide 16361A 3.INSTALL FAN AND GENERATOR V BELT

Hide 51107A 4.INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

Hide 5.INSPECT FOR ENGINE OIL LEAK

Hide 51443C 6.INSTALL REAR ENGINE UNDER COVER RH

Hide 51441 7.INSTALL NO. 1 ENGINE UNDER COVER

Hide 8.INSTALL FRONT WHEEL RH