Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › 2016.10–2019.09
RM32H0E _52 Drivetrain _059517 AXLE AND DIFFERENTIAL _0291569 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for 2WD)

a.

Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 42450B 2.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for AWD)

a.
C345048C04
2.344,1.729 2.344,0.781 2.344,0.781 2.646,0.781 true 2.354,1.104 2.781,1.104 true 2.271,1.729 2.563,1.938 0.292,0.208 10 false *a
*a Matchmark


Align the matchmarks on the rear drive shaft assembly and rear axle hub and bearing assembly.

NOTICE:

Be careful not to damage the thread portion of the rear drive shaft assembly.



b.

Install the rear axle hub sub-assembly and rear disc brake dust cover to the rear axle carrier with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)

NOTICE:

Be careful not to damage the drive shaft boot.



Hide 42431 3.INSTALL REAR DISC

Hide 4.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42312B 5.TEMPORARILY TIGHTEN REAR AXLE SHAFT NUT

a.

Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using non-residue solvent.

NOTICE:
·

Be sure to perform this work even when using a new rear drive shaft assembly.

·

Keep the threaded parts free of oil and foreign matter.




b.

Using a 30 mm socket wrench, install the rear axle shaft nut.

Torque:
216 N*m (2203 kgf*cm, 159 ft.*lbf)

NOTICE:

Stake the rear axle shaft nut after inspecting for looseness and runout in the following steps.


HINT:

Depress the brake pedal to prevent the drive shaft from rotating.



Hide 6.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42431 7.REMOVE REAR DISC

Hide 8.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 42431 10.INSTALL REAR DISC

Hide 11.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 12.STAKE REAR AXLE SHAFT NUT

a.
C345051

Using a chisel and hammer, stake the rear axle shaft nut.


Hide 13.CONNECT SKID CONTROL SENSOR WIRE (for 2WD)

a.

Connect the skid control sensor connector to the rear axle hub and bearing assembly.


Hide 14.CONNECT SKID CONTROL SENSOR WIRE (for AWD)

a.

Connect the skid control sensor connector to the rear axle hub and bearing assembly.


Hide 15.INSTALL REAR WHEEL