Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE CARRIER (for 2WD) › 2016.10–2019.09
RM32H0E _52 Drivetrain _059517 AXLE AND DIFFERENTIAL _0291570 REAR AXLE CARRIER(for 2WD) A

AXLE AND DIFFERENTIAL  REAR AXLE CARRIER(for 2WD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.TEMPORARILY INSTALL REAR AXLE CARRIER SUB-ASSEMBLY

a.
C345053

Temporarily install the rear axle carrier sub-assembly to the rear upper control arm assembly with the bolt and nut.

NOTICE:
·

Insert the bolt with the threaded end facing the rear of the vehicle.

·

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.




b.

Temporarily install the rear shock absorber assembly to the rear axle carrier sub-assembly with the nut.

NOTICE:

Hold the rear axle carrier pin while rotating the nut.



c.

Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts.

Torque:
135 N*m (1377 kgf*cm, 100 ft.*lbf)


Hide 2.INSTALL FLEXIBLE HOSE BRACKET

a.

Install the flexible hose bracket to the rear axle carrier sub-assembly with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 48720A 3.TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

Hide 48258C 4.INSTALL REAR LOWER COIL SPRING INSULATOR

Hide 48231B 5.INSTALL REAR COIL SPRING

Hide 48790 7.INSTALL REAR UPPER CONTROL ARM ASSEMBLY

a.

Install the rear upper control arm assembly to the rear axle carrier sub-assembly with the bolt.

Torque:
73 N*m (744 kgf*cm, 54 ft.*lbf)

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.



Hide 48720A 8.INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

Hide 48740F 9.INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY

a.

Install the rear No. 2 suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

Click hereSuspension>REAR SUSPENSION>REAR LOWER ARM>INSTALLATION


Hide 48540 10.INSTALL REAR SHOCK ABSORBER ASSEMBLY

Hide 48840A 11.INSTALL REAR STABILIZER LINK ASSEMBLY

Hide 42450B 12.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

Hide 13.CONNECT SKID CONTROL SENSOR WIRE

Hide 42431 14.INSTALL REAR DISC

Hide 15.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 89408C 16.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)

Hide 17.INSTALL REAR WHEEL

Hide 48740F 18.INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY

a.

Install the rear No. 2 suspension arm assembly (rear suspension member sub-assembly side) with the nut.

Click hereSuspension>REAR SUSPENSION>REAR LOWER ARM>INSTALLATION


Hide 19.INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Hide 21.PERFORM INITIALIZATION (w/ Height Control Sensor)