Home › Drivetrain › K114 (MULTIDRIVE / CVT) › PARK / NEUTRAL POSITION SWITCH
RM32H0E _52 Drivetrain _059616 K114 MULTIDRIVE / CVT _0292457 PARK / NEUTRAL POSITION SWITCH A

K114 MULTIDRIVE / CVT  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51444A 2.REMOVE REAR ENGINE UNDER COVER LH

Hide 53141F 4.REMOVE RADIATOR COVER

Hide 17751 5.REMOVE NO. 1 AIR CLEANER INLET

Hide 17705 6.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 17701 7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 33820B 8.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C300685

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


c.

Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.


Hide 84540 9.REMOVE PARK/NEUTRAL POSITION SWITCH

a.
C302120

Disconnect the connector.


b.
C296023

Remove the nut, washer and control shaft lever from the park/neutral position switch.


c.
C296026

Using a screwdriver, pry out the lock plate and remove the lock nut and lock plate from the park/neutral position switch.


d.
C296027

Remove the 2 bolts and park/neutral position switch from the continuously variable transaxle assembly.