Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › TRANSFER CASE FRONT OIL SEAL (for RH Side)
RM32H0E _52 Drivetrain _059725 GF1A TRANSFER / 4WD / AWD _0292791 TRANSFER CASE FRONT OIL SEAL(for RH Side) A

GF1A TRANSFER / 4WD / AWD  TRANSFER CASE FRONT OIL SEAL(for RH Side)  REPLACEMENT  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the transfer case oil seal RH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Front wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)

PROCEDURE

Hide 43457 2.REMOVE DRIVE SHAFT BEARING BRACKET

Hide 36113D 3.REMOVE TRANSFER CASE OIL SEAL RH

C130039C03
2.031,1.458 2.031,1.708 false 1.458,0.5 2.354,0.5 false 1.896,1.719 2.323,1.906 0.427,0.188 10 false SST 2.365,0.406 2.542,0.563 0.177,0.156 10 false *1
*1 Transfer Case Oil Seal RH


a.

Using SST, remove the transfer case oil seal RH from the No. 1 transfer case cover.

SST
09308-00010  

NOTICE:

Do not scratch the press-fitting surface of the transfer case oil seal RH.



Hide 36113D 4.INSTALL TRANSFER CASE OIL SEAL RH

C156138C03
2.271,0.188 1.729,0.781 false 2.594,0.479 2.229,0.802 false 2.635,0.396 3.052,0.604 0.417,0.208 10 SST 2.333,0.083 2.625,0.26 0.292,0.177 10 *1 2.208,1.823 2.521,1.979 0.313,0.156 10 (A)
*1 Transfer Case Oil Seal RH


a.

Coat the lip of a new drive shaft oil seal RH with MP grease.


b.

Using SST and a hammer, tap in a new transfer case oil seal RH as shown in the illustration.

SST
09316-60011  (09316-00011)

Drive in depth (A):

7.5 to 8.5 mm (0.296 to 0.334 in.)


NOTICE:
·

Tap the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.

·

Do not tap the transfer case oil seal RH in too far.




Hide 43457 5.INSTALL DRIVE SHAFT BEARING BRACKET

Hide 8.INSPECT TRANSFER OIL LEAK