Home › Engine / Hybrid System › 3ZR-FAE (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL
RM32H0E _51 Engine / Hybrid System _059726 3ZR-FAE ENGINE MECHANICAL _0292815 FRONT CRANKSHAFT OIL SEAL A

3ZR-FAE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11302A 1.INSTALL TIMING CHAIN COVER OIL SEAL

a.

Apply MP grease to the lip of a new timing chain cover oil seal.

NOTICE:

Keep the lip free from foreign matter.



b.
A157500C05
1.573,1.823 1.333,0.385 1.333,0.385 1.125,0.385 false 0.771,0.313 1.063,0.5 0.292,0.188 10 false SST 2.563,0.156 2.875,0.313 0.313,0.156 10 false *a
*a Tap in Depth


Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly retainer edge.

SST
09223-22010  

Timing Chain Oil Seal Tap in Depth:

-1.0 to 1.0 mm (-0.0394 to 0.0394 in.)


NOTICE:
·

Wipe off excess grease from the crankshaft.

·

Do not tap in the timing chain cover oil seal at an angle.




Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.

Align the crankshaft timing gear key with the crankshaft pulley set key groove of the crankshaft pulley.


b.
A234915C01
1.479,1.813 2.427,0.51 2.427,0.51 1.823,1.75 true 0.531,2.385 0.719,2.552 0.188,0.167 10 *a 2.229,3.125 2.417,3.292 0.188,0.167 10 *b 2.375,0.313 2.667,0.458 0.292,0.146 10 SST
*a Turn
*b Hold


Using SST, hold the crankshaft pulley in place and tighten the crankshaft pulley set bolt.

SST
09213-54015  (91551-00850)
09330-00021  

Torque:
190 N*m (1937 kgf*cm, 140 ft.*lbf)


Hide 16361A 3.INSTALL FAN AND GENERATOR V BELT

Hide 51107A 5.INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

Hide 51443C 7.INSTALL REAR ENGINE UNDER COVER RH

Hide 51441 8.INSTALL NO. 1 ENGINE UNDER COVER

Hide 9.INSTALL FRONT WHEEL RH