Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › ECM › 2016.10–2020.08
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293872 ECM A

3ZR-FAE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89668 1.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89667E 2.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89661 3.INSTALL ECM

a.

Install the ECM with the bolt and nut.

Torque:
Bolt : 12.5 N*m (127 kgf*cm, 9 ft.*lbf)
Nut : 8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If the ECM has been struck or dropped, replace it.



b.

Engage the 2 claws to connect the engine wire to the No. 1 engine room relay block.


c.

Connect the 3 connectors to the engine room relay block assembly.


d.

Install the No. 1 relay block cover to the No. 1 engine room relay block.


e.
A393531

Connect the 2 ECM connectors and lower the 2 levers.

NOTICE:
·

When connecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

·

Be sure to securely connect the ECM connectors.




Hide 17701 4.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

a.

Install the air cleaner case sub-assembly to the vehicle with the 2 bolts.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


b.

Install the air cleaner filter element sub-assembly to the air cleaner case sub-assembly.


Hide 17751 5.INSTALL NO. 1 AIR CLEANER INLET

Hide 53141F 6.INSTALL RADIATOR COVER

Hide 7.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>3ZR-FAE BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 10.PERFORM INITIALIZATION