Home › Engine / Hybrid System › 8NR-FTS (INTAKE / EXHAUST) › INTAKE MANIFOLD
RM32H0E _51 Engine / Hybrid System _059908 8NR-FTS INTAKE / EXHAUST _0293886 INTAKE MANIFOLD A

8NR-FTS INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effects/Inoperative when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 25860 3.REMOVE PURGE VALVE (PURGE VSV)

Hide 22030 6.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A355591C02
0.719,1.74 0.927,1.74 0.927,1.74 1.135,1.323 true 2.25,1.844 2.073,1.844 2.073,1.844 1.771,1.427 true 0.49,1.656 0.75,1.844 0.26,0.188 10 true *1 2.271,1.781 2.49,1.979 0.219,0.198 10 true *2
*1 No. 1 Water By-pass Hose
*2 No. 2 Water By-pass Hose


Disconnect the throttle body with motor assembly connector.


b.

Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.


c.

Remove the throttle body with motor assembly from the intake manifold.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



Hide 22271 7.REMOVE THROTTLE BODY GASKET

a.
A353830

Remove the throttle body gasket from the intake manifold.


Hide 82121 8.DISCONNECT ENGINE WIRE

a.
A353273

Disengage the wire harness clamp.


b.
A353279

Remove the bolt and wire harness clamp bracket from the intake manifold.


c.
A353274

Disengage the wire harness clamp from the wire harness clamp bracket.


d.
A353275

Remove the bolt and wire harness clamp bracket from the intake manifold.


e.
A353276

Disconnect the No. 2 water by-pass hose from the intake manifold.


f.
A353277

Remove the bolt and disengage the wire harness clamp from the cylinder block sub-assembly.


Hide 23829 9.REMOVE NO. 3 FUEL VAPOR FEED HOSE

a.
A353278

Slide the clip and remove the No. 3 fuel vapor feed hose from the intake manifold.


Hide 17111 10.REMOVE INTAKE MANIFOLD

a.
A353280

Remove the 5 bolts and intake manifold from the cylinder head sub-assembly.


Hide 17177 11.REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET

a.
A353281

Remove the No. 1 intake manifold to head gasket from the intake manifold.


Hide 12.REMOVE STUD BOLT

a.
A355592

Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.