Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › 2016.10–2018.05
RM32H0E _59 Vehicle Exterior _060017 DOOR / HATCH _0295664 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RHD and LHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE FRONT BUMPER ASSEMBLY

Hide 75602A 3.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY

Hide 4.REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY

Hide 53876A 5.REMOVE FRONT FENDER LINER LH

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL


Hide 53117C 6.REMOVE NO. 1 RADIATOR GRILLE RETAINER

Hide 16561C 7.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL

Hide 53510 9.REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)

Hide 53510 10.REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

a.
B450728C01
1.948,1.708 1.729,1.427 true 1.938,1.74 2.156,1.938 0.219,0.198 10 true *a
*a Hood Lock Bolt


Remove the 2 bolts and hood lock bolt.


b.
B450729

Disengage the guide to remove the hood lock assembly from the hood lock control cable assembly.


Hide 53601 11.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 53632 12.REMOVE HOOD LOCK CONTROL CABLE HOLDER

B460893C03
0,0 0,0 false
V113147

Remove in this Direction


a.

Disengage the claw to remove the hood lock control cable holder as shown in the illustration.


Hide 53601 13.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B338115

Remove the hood lock control lever sub-assembly from the hood lock control cable assembly.


Hide 53630 14.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

a.

Disconnect the hood lock control cable assembly from the clamps.

B450731C01
2.813,0.615 3.781,0.615 true 2.615,0.521 2.927,0.677 0.313,0.156 10 false *a
*a Grommet - -



b.

Disengage the grommet.


c.

Pull the hood lock control cable assembly from the engine compartment to remove it.


Hide 53630 15.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

a.

Disconnect the hood lock control cable assembly from the clamps.

B450732C01
4.573,0.563 5.26,0.563 true 5.333,0.458 5.656,0.719 0.323,0.26 10 false *a
*a Grommet - -



b.

Disengage the grommet.


c.

Pull the hood lock control cable assembly from the engine compartment to remove it.