Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. REPAIR INSTRUCTION
75988E
2.INSTALL REAR DOOR OUTSIDE STRIPE
Refer to the illustration to position a new rear door outside stripe.
| *A | LH Side | *B | RH Side |
| *a | Point A | *b | Point B |
| *c | Edge of Curved Surface | *d | Straight |
| *e | Triangle | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 1.0 mm (0.0394 in.) | B | 10.0 mm (0.394 in.) |
| C | 1.0 mm (0.0394 in.) | D | 2.5 mm (0.0984 in.) |
Remove the release paper and install the rear door outside stripe.
Align the point (B) on the rear door outside stripe with the point (A) on the door frame and install the rear door outside stripe.
75978H
3.INSTALL REAR DOOR LOWER OUTSIDE STRIPE
Refer to the illustration to position a new rear door lower outside stripe.
| *A | LH Side | *B | RH Side |
| *a | Point A | *b | Point B |
| *c | Edge of Curved Surface | *d | Straight |
| *e | Triangle | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 10.0 mm (0.394 in.) | B | 5.0 mm (0.197 in.) |
| C | -1.0 to 1.0 mm (-0.0394 to 0.0394 in.) | D | 1.0 mm (0.0394 in.) |
Remove the release paper and install the rear door lower outside stripe.
Align the point (B) on the rear door lower outside stripe with the point (A) on the door frame and install the rear door lower outside stripe.
68124B
4.INSTALL REAR DOOR QUARTER WINDOW GLASS
68152C
5.INSTALL REAR DOOR GLASS RUN
67674A
6.INSTALL REAR DOOR FRAME GARNISH
68104
7.INSTALL REAR DOOR GLASS SUB-ASSEMBLY
67408F
8.INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY
67872
9.INSTALL REAR DOOR WEATHERSTRIP
67842E
10.INSTALL REAR DOOR SERVICE HOLE COVER
68197
11.INSTALL REAR DOOR BELT SEAL
68174A
12.INSTALL REAR DOOR GLASS INNER WEATHERSTRIP
68199
13.INSTALL REAR DOOR BELT REAR SEAL
67604
14.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
67498
15.INSTALL REAR DOOR REAR FRAME BRACKET
74272A
16.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
69284D
17.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
18.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 8NR-FTS:
for 3ZR-FAE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
19. INITIALIZE POWER WINDOW CONTROL SYSTEM
20.INSPECT POWER WINDOW OPERATION