Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for 3ZR-FAE)
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0299737 VACUUM PUMP(for 3ZR-FAE) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 3ZR-FAE)  INSTALLATION  


PROCEDURE

Hide 29300 1.INSTALL VACUUM PUMP ASSEMBLY

a.

When installing a new vacuum pump assembly:

i.
C169250C01
1.333,1.646 1.333,1.823 1.333,1.823 1.188,1.823 false 1.844,1.104 1.844,0.208 1.844,0.208 2.083,0.208 true 1,1.771 1.583,2.021 0.583,0.25 10 *2 2.115,0.156 2.5,0.375 0.385,0.219 10 *1
*1 No. 2 O-ring
*2 No. 3 O-ring


Apply engine oil to the No. 2 O-ring and No. 3 O-ring which are installed to a new vacuum pump assembly.



b.

When reusing the vacuum pump assembly:

i.
C169250C01
1.333,1.646 1.333,1.823 1.333,1.823 1.188,1.823 false 1.844,1.104 1.844,0.208 1.844,0.208 2.083,0.208 true 1,1.771 1.583,2.021 0.583,0.25 10 *2 2.115,0.156 2.5,0.375 0.385,0.219 10 *1
*1 No. 2 O-ring
*2 No. 3 O-ring


Apply engine oil to a new No. 2 O-ring and No. 3 O-ring and install them to the vacuum pump assembly.



c.
C366924C01
1.25,0.854 1.729,0.458 true 1.583,1.656 2.115,1.344 true 1.802,0.281 2.063,0.5 0.26,0.219 10 true *b 1.281,1.635 1.542,1.854 0.26,0.219 10 true *a
*a Coupling Teeth
*b Groove
V100135

Engine Oil


Apply engine oil to the inner surface of the installation hole.


d.

Install the vacuum pump assembly so that the coupling teeth of the vacuum pump assembly and the groove of the camshaft are engaged.

NOTICE:

Ensure that the vacuum pump assembly is installed securely.



e.
C366923N01
1.771,1.771 1.927,1.969 0.156,0.198 10 true A 3.104,1.031 3.26,1.229 0.156,0.198 10 true B 3.135,1.708 3.292,1.906 0.156,0.198 10 true B

Install the 3 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:

After tightening the bolts, ensure that the contact surface of the vacuum pump assembly is flush with the cylinder head.


HINT:
Length of the Bolt
Bolt A 25 mm (0.984 in.)
Bolt B 45 mm (1.77 in.)



f.

Connect the union to connector tube hose to the vacuum pump assembly and slide the clip to secure it.


Hide 2.CONNECT UNION TO CONNECTOR TUBE HOSE

a.

Connect the union to connector tube hose to the vacuum pump assembly and slide the clip to secure it.