This DTC is output when a headlight ECU sub-assembly LH that is incompatible with the vehicle is installed.
The headlight ECU sub-assembly LH outputs DTC B2456.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2456 | Left Headlight ECU Variation Error | Headlight ECU sub-assembly LH variation mismatch | ·
Headlight ECU sub-assembly LH ·
ECM ·
Main body ECU (multiplex network body ECU) |
- |
After the headlight ECU sub-assembly LH is replaced, vehicle information registration and initialization are necessary.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
Before replacing the ECM or main body ECU (multiplex network body ECU), refer to Service Bulletin.*1
*1: w/ Entry and Start System
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
Turn on the headlights using the light control switch.
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B2456 output does not occur | A |
| DTC B2456 output occurs | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Check that the ECM part number matches the vehicle.
| Result | Proceed to |
|---|---|
| ECM part number matches vehicle | A |
| ECM part number does not match (for 3ZR-FAE) | B |
| ECM part number does not match (for 8NR-FTS) | C |
A
B
C
Check that the main body ECU (multiplex network body ECU) part number matches the vehicle.
| Result | Proceed to |
|---|---|
| Main body ECU (multiplex network body ECU) part number matches vehicle | A |
| Main body ECU (multiplex network body ECU) part number does not match (for LHD) | B |
| Main body ECU (multiplex network body ECU) part number does not match (for RHD) | C |
A
B
C