Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 1) › 2018.05–2019.09
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0358465 AIR FUEL RATIO SENSOR(for Sensor 1) A

8NR-FTS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of air fuel ratio sensor (sensor 1) Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Gas leak from exhaust system is repaired

CAUTION:
·
A344783

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust manifold.

·

Touching high-temperature areas such as the engine and exhaust manifold could result in burns.



PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55737B 2.REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

Hide 55735A 3.REMOVE WATER GUARD PLATE LH

Hide 55736D 4.REMOVE COWL BODY MOUNTING REINFORCEMENT LH

Hide 55735C 5.REMOVE COWL BODY MOUNTING REINFORCEMENT RH

Hide 55701J 6.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55701J 7.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 51441 8.REMOVE NO.1 ENGINE UNDER COVER

Hide 55225 9.REMOVE DASH PANEL HEAT INSULATOR (for LHD)

Hide 55225 10.REMOVE DASH PANEL HEAT INSULATOR (for RHD)

Hide 89467B 11.REMOVE AIR FUEL RATIO SENSOR

a.
A393623

Disengage the wire harness clamp.


b.

Disconnect the air fuel ratio sensor connector.


c.
A393624N01
0.948,1.344 1.719,1.667 true 1.813,1.594 2.156,1.771 0.344,0.177 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly.

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.