Home › Drivetrain › K114 (MULTIDRIVE / CVT) › REVOLUTION SENSOR › 2019.09–2020.08
RM32H0E _52 Drivetrain _059616 K114 MULTIDRIVE / CVT _0292455 REVOLUTION SENSOR A

K114 MULTIDRIVE / CVT  REVOLUTION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission revolution sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Toyota parking assist-sensor system*1 (Click here)
Simple intelligent parking assist system*1
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>3ZR-FAE BATTERY>REMOVAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 28800 3.REMOVE BATTERY

Hide 53141F 5.REMOVE RADIATOR COVER

Hide 17751 6.REMOVE NO. 1 AIR CLEANER INLET

Hide 17705 7.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 74404A 10.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 89413P 11.REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)

C296015

a.

Disconnect the connector.


b.

Remove the bolt and transmission revolution sensor (NIN) from the continuously variable transaxle assembly.


c.

Remove the O-ring from the transmission revolution sensor (NIN).


Hide 89413M 12.REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)

C296016

a.

Disconnect the connector.


b.

Remove the bolt and transmission revolution sensor (NOUT) from the continuously variable transaxle assembly.


c.

Remove the O-ring from the transmission revolution sensor (NOUT).


Hide 89413N 13.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

C296014

a.

Disconnect the connector.


b.

Remove the bolt and transmission revolution sensor (NT) from the continuously variable transaxle assembly.


c.

Remove the O-ring from the transmission revolution sensor (NT).