Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Single Beam Headlight) › from 2020.08
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0406609 HEADLIGHT ASSEMBLY(for Single Beam Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Single Beam Headlight)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSTALL HEADLIGHT ASSEMBLY

a.
E420070C01
0,0 0,0 false
V113147

Install in this Direction


Temporarily install the headlight assembly as shown in the illustration.


b.

Install the headlight assembly with the bolt and 3 screws.

Torque:
Bolt : 5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.
E420075C01
2.521,2.708 2.354,2.917 true 2.198,2.896 2.406,3.094 0.208,0.198 10 true *a 3.052,1.927 3.24,2.125 0.188,0.198 12 true A 1.354,2.865 1.542,3.063 0.188,0.198 12 true B
*a Connector Lock Lever
V113147

Install in this Direction


Connect the connector A.


d.

Connect the connector B and raise the connector lock lever to engage the claw and lock the connector as shown in the illustration.


e.

Remove the protective tape.


Hide 85319A 2.INSTALL INLET HOSE (for RH Side)

a.

Install the inlet hose with the clip.


Hide 3.INSTALL FRONT BUMPER ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART