The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission control cable assembly removal/installation are shown below.
When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.
Touching high-temperature areas such as the engine and exhaust pipe could result in burns.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
28800
4.REMOVE BATTERY
33504F
5.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
6.REMOVE REAR CONSOLE BOX ASSEMBLY
53141F
7.REMOVE RADIATOR COVER
17751
8.REMOVE NO. 1 AIR CLEANER INLET
17705
9.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17701
10.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
89661
11.REMOVE ECM
74404A
12.REMOVE BATTERY CLAMP SUB-ASSEMBLY
57533B
13.REMOVE FRONT FLOOR CENTER BRACE
17420K
14.REMOVE NO. 2 CENTER EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
17410
15.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58151
16.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Remove 3 nuts and front No. 1 floor heat insulator from the vehicle body.
33820B
17.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
for TMMT Made:
|
Remove in this Direction |
Disconnect the end of the transmission control cable assembly from the floor shift shift lever assembly.
| *1 | Slider |
|
Push |
|
Remove in this Direction |
Push in the slider and remove the transmission control cable from the shift lever assembly as shown in the illustration
for TMC Made:
|
Remove in this Direction |
Disconnect the end of the transmission control cable assembly from the floor shift shift lever assembly.
| *1 | Nut |
|
Rotate approximately 180° |
|
Remove in this Direction |
Rotate the nut approximately 180° in the direction shown in the illustration, and while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever plate.
Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.
Remove the nut to disconnect the transmission control cable assembly from the control shaft lever.
Remove the clip to separate the transmission control cable assembly from the No. 1 transmission control cable bracket.
Remove the nut.
Disengage the guide to disconnect the transmission control cable assembly from the vehicle body.
Remove the 2 nuts and transmission control cable assembly from the vehicle body.