Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
73997
1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG DOOR (for TMMT Made)
Engage the hooks.
Engage the hooks to install the lower No. 1 instrument panel airbag door to the lower No. 1 instrument panel airbag assembly.
73900
2.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY WITH DOOR
Check that the ignition switch off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| *a | Airbag Connector |
| *b | Airbag Connector Lock |
Connect the airbag connector to the lower No. 1 instrument panel airbag assembly with door.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock to install the airbag connector.
Securely lock the airbag connector lock.
Engage the hooks to temporarily install the lower No. 1 instrument panel airbag assembly with door.
Install the 2 bolts.
Confirm that the lower No. 1 instrument panel airbag assembly with door is installed securely without any excessive gaps and is not protruding outward.
55434B
3.INSTALL INSTRUMENT PANEL LOWER CENTER FINISH PANEL
55470
4.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
55545
5.INSTALL FUSE BOX OPENING COVER
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 8NR-FTS:
for 3ZR-FAE:
7. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
8. PERFORM DIAGNOSTIC SYSTEM CHECK
9.INSPECT SRS WARNING LIGHT