Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › ECM › from 2020.08
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293872 ECM A

3ZR-FAE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89668 1.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89667E 2.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89661 3.INSTALL ECM

a.

Install the ECM with the bolt and nut.

Torque:
Bolt : 12.5 N*m (127 kgf*cm, 9 ft.*lbf)
Nut : 8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If the ECM has been struck or dropped, replace it.



b.

Engage the 2 claws to connect the engine wire to the No. 1 engine room relay block.


c.

Connect the 3 connectors to the engine room relay block assembly.


d.

Install the No. 1 relay block cover to the No. 1 engine room relay block.


e.
A393531

Connect the 2 ECM connectors and lower the 2 levers.

NOTICE:
·

When connecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

·

Be sure to securely connect the ECM connectors.




Hide 17701 4.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

a.

Install the air cleaner case sub-assembly to the vehicle with the 2 bolts.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


b.

Install the air cleaner filter element sub-assembly to the air cleaner case sub-assembly.


Hide 17751 5.INSTALL NO. 1 AIR CLEANER INLET

Hide 53141F 6.INSTALL RADIATOR COVER

Hide 7.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 10. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Hide 11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL