U0129 Lost Communication with Skid Control ECU
Diagnostic trouble codes · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The combination meter assembly communicates with the skid control ECU via the CAN communication lines (CAN No. 1 Bus).| DTC No. |
DTC Detection Conditions |
Trouble Areas |
| U0129 |
When IG voltage is 9.5 V or more and the following condition is detected:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CONFIRM DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Ignition switch on (IG).
Turn the tester on.
Clear the stored DTCs by selecting the following menu items on the tester: Body / Combination Meter / DTC Info / Clear Codes.
Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.
Stop the vehicle.
Check for DTCs (Click here for LHD without Smart Entry and Start System, Click here for LHD with Smart Entry and Start System, Click here for RHD without Smart Entry and Start System, Click here for RHD with Smart Entry and Start System).
- Result:
Result
Proceed to
DTC is output.
A (Click here for LHD without Smart Entry and Start System, Click here for LHD with Smart Entry and Start System, Click here for RHD without Smart Entry and Start System, Click here for RHD with Smart Entry and Start System)
DTC is not output.
B
|
|
||||
| A | ||
| ||
