RESULT LIST OF HOW TO PROCEED WITH TROUBLESHOOTING:
Symptom
| Suspected Area
| See page
|
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in CAN Main Bus Wire"
| Open in CAN Main Bus Wire
|
Click here
|
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short in CAN Bus Wires"
| Short in CAN Bus Wires
|
Click here
|
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to +B in CAN Bus Wire"
| Short to B+ in CAN Bus Wire
|
Click here
|
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to GND in CAN Bus Wire"
| Short to GND in CAN Bus Wire
|
Click here
|
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in One Side of CAN Sub Bus Wire"
| Open in One Side of CAN Branch Wire
|
Click here
|
COMMUNICATION STOP MODE TABLE:
Symptom
| Suspected Area
| See page
|
"ABS/VSC/TRAC" is not displayed on the intelligent tester (with VSC)
| Skid Control ECU Communication Stop Mode
|
Click here
|
"A/C " is not displayed on the intelligent tester
| Air Conditioning Amplifier Communication Stop Mode
|
Click here
|
"Body/Gateway" is not displayed on the intelligent tester
| Main Body ECU Communication Stop Mode
|
Click here
|
"Steering Angle Sensor" is not displayed on the intelligent tester
| Steering Angle Sensor Communication Stop Mode*
|
Click here
|
"Yaw Rate/Deceleration Sensor" is not displayed on the intelligent tester
| Yaw Rate Sensor Communication Stop Mode*
|
Click here
|
"Engine" is not displayed on the intelligent tester
| ECM Communication Stop Mode
|
Click here
|
"Meter " is not displayed on the intelligent tester
| Combination Meter Communication Stop Mode
|
Click here
|
"SRS Airbag" is not displayed on the intelligent tester
| Center Airbag Sensor Communication Stop Mode
|
Click here
|