Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of the problem symptom. The potential cases of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


ENGINE IMMOBILISER SYSTEM: 
Symptom
Suspected Area
See page
Unable to register the key.
1. Door courtesy switch circuit
Click here
2. ECU power source circuit
Click here
3. Transponder key ECU assembly
-
Engine does not start.
1. Key
Click here
2. ECU power source circuit
Click here
3. Transponder key ECU assembly
-
4. SFI system (2AZ-FE)
Click here
5. SFI system (2GE-FE)
Click here
Security indicator is always ON.
1. Security indicator light circuit
Click here
2. ECU power source circuit
Click here
3. Transponder key ECU assembly
-
Security indicator is OFF.
1. Security indicator light circuit
Click here
2. ECU power source circuit
Click here
3. Transponder key ECU assembly
-
Security indicator is blinking abnormally.
Transponder key ECU assembly
-
No code is output.
1. Diagnosis circuit
Click here
2. ECU power source circuit
Click here
3. Transponder key ECU assembly
-

HINT:
  1. If the engine does not start, check that the key which did not start the engine control system has been registered, and that it is possible to start with another registered key.
  1. If the security indicator is always ON, finish the automatic registration mode in case the mode still operates.