Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

DTC    C1AE9    Rear Right Sensor Malfunction

for Preparation Click here


DESCRIPTION

The No. 1 ultrasonic sensor (rear right sensor) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear right sensor). If the No. 1 ultrasonic sensor (rear right sensor) has an open or other malfunction, it will not function normally.

DTC No.
DTC Detection Condition
Trouble Area
C1AE9
A malfunction of the No. 1 ultrasonic sensor (rear right sensor).
  1. No. 1 ultrasonic sensor (rear right sensor)
  2. Clearance warning ECU

INSPECTION PROCEDURE

NOTICE:
If the DTC is output after repairs, turn the ignition switch to ON and turn the clearance sonar main switch on. Then clear the DTC (Click here).

1.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    Only DTC C1AE9 is output
    A
    DTC C1AE9 and C1AED are output
    B
    No DTC is output
    C



B
GO TO DTC (C1AED) (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A


2.REPLACE NO. 1 ULTRASONIC SENSOR (REAR RIGHT SENSOR)


    E149965E13
  1. Replace the No. 1 ultrasonic sensor (rear right sensor) with a normally functioning sensor (Click here).

    HINT:
    All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.


NEXT


3.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC C1AE9 is output
    A
    No DTC is output
    B



B
END (REAR RIGHT SENSOR WAS DEFECTIVE)
A

REPLACE CLEARANCE WARNING ECU (Click here)