1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
86120
3.REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for LHD)
86120L
4.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for LHD)
67914
5.REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)
62112A
6.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)
62312B
7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH (for LHD)
55318C
8.REMOVE INSTRUMENT SIDE PANEL LH (for LHD)
55650
9.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)
55474C
10.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for LHD)
55410C
11.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for LHD)
53922B
12.REMOVE FRONT PANEL GARNISH LH (for LHD)
53601
13.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for LHD)
55432D
14.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD)
55480D
15.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD)
89611
16.REMOVE ENGINE SWITCH (for LHD)
Disengage the 2 claws and remove the engine switch.
67911B
17.REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)
62111A
18.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)
62311B
19.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH (for RHD)
55317A
20.REMOVE INSTRUMENT SIDE PANEL RH (for RHD)
55431B
21.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)
89611
22.REMOVE ENGINE SWITCH (for RHD)
Disengage the 2 claws and remove the engine switch.