Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for LHD) › from 2015.04
RM19V0EQ _54 Brake _014592 BRAKE SYSTEM (OTHER) _0074044 BRAKE MASTER CYLINDER(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 3.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

a.
C239198

Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.


b.
C239185

Remove the 10 bolts and front outer cowl top panel sub-assembly.


Hide 53295E 4.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 5.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17735 6.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 7.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 47201 9.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.
C239200

Disconnect the reservoir level switch connector and disengage the clamp.


b.
C239863

Using a union nut wrench, disconnect the 6 brake lines and remove the brake master cylinder to way tube from the brake master cylinder sub-assembly.

NOTICE:
·

Do not damage or deform the brake lines during the removal procedure.

·

Do not allow any foreign matter such as dirt or dust to enter the brake lines.




c.
C239864C01
2.729,3.667 3,3.667 false 3,3.594 3.375,3.875 0.375,0.281 10 *1
*1 Master Cylinder Piston


Remove the 2 nuts, front brake tube way and brake master cylinder sub-assembly from the brake booster assembly.

NOTICE:
·

Do not hold the brake master cylinder sub-assembly by the master cylinder piston. Hold the brake master cylinder sub-assembly by its body or its reservoir when carrying it.

·

Do not pull out the master cylinder piston.

·

Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.

·

When installing the brake master cylinder sub-assembly to the brake booster assembly, or when removing the brake master cylinder sub-assembly from the brake booster assembly, make sure that the brake master cylinder sub-assembly is kept horizontal or with its tip facing downward (the master cylinder piston is facing upward) to prevent the master cylinder piston from falling out.

·

Do not allow any foreign matter to contaminate the master cylinder piston. If any foreign matter gets on the master cylinder piston, remove it by using a piece of cloth and then apply an even layer of lithium soap base glycol grease around the circumference (sliding part) of the master cylinder piston.

·

Do not use any other types of grease.




Hide 47201B 10.REMOVE BRAKE MASTER CYLINDER O-RING

a.

Remove the brake master cylinder O-ring from the brake master cylinder sub-assembly.