1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE REAR CONSOLE BOX ASSEMBLY
4.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55660
5.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
58916
6.REMOVE BOX BOTTOM MAT
58804A
7.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
8.REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)
9.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System)
86211
10.REMOVE NO. 1 RADIO BRACKET (w/o Navigation System)
86212
11.REMOVE NO. 2 RADIO BRACKET (w/o Navigation System)
86211
12.REMOVE NO. 1 RADIO BRACKET (w/ Navigation System)
86212
13.REMOVE NO. 2 RADIO BRACKET (w/ Navigation System)
55900
14.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Disengage the 4 clips and guide, and remove the air conditioning control assembly as shown in the illustration.