Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The ECM of this system is connected to the CAN and multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication systems.
  2. *: Use the Intelligent tester



1.Vehicle Brought to Workshop

    NEXT


    2.Customer Problem Analysis

      NEXT


      3.Connect the Intelligent tester to the DLC3*

        NEXT


        4.Check and Clear DTCs and Freeze Frame Data*

          HINT:
          (Click here).


        NEXT


        5.Visual Inspection

          NEXT


          6.Setting the Check Mode Diagnosis*

            HINT:
            (Click here).


          NEXT


          7.Problem Symptom Confirmation

            HINT:
            (Click here).



          .
          Symptom does not occur: Go to step 8

          .
          Symptom occurs: Go to step 9

          8.Symptom Simulation

            HINT:
            (Click here).


          NEXT


          9.DTC Check*

            HINT:
            (Click here).



          .
          DTC is not output: Go to step 10

          .
          DTC is output: Go to step 17

          10.Basic Inspection

            HINT:
            (Click here and Click here).



          NG.
          Go to step 19
          OK


          11.Mechanical System Test

            HINT:
            (Click here).



          NG.
          Go to step 16
          OK


          12.Hydraulic Test

            HINT:
            (Click here).



          NG.
          Go to step 16
          OK


          13.Manual Shifting Test

            HINT:
            (Click here).



          NG.
          Go to step 15
          OK


          14.Problem Symptoms Table Chapter 1

            HINT:
            (Click here).



          NG.
          Go to step 18
          OK


          15.Problem Symptoms Table Chapter 2

            HINT:
            (Click here).


          NEXT


          16.Part Inspection


            .
            Go to step 19

            17.DTC Chart

              HINT:
              (Click here).


            NEXT


            18.Circuit Inspection

              NEXT


              19.Repair or Replace

                NEXT


                20.Confirmation Test

                  NEXT

                  End