DTC C1429 Open or Short in Brake Pedal Load Sensing Switch |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1429 | An open or short in the brake pedal load sensing switch circuit continues for 0.5 seconds or more. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (BRAKE PEDAL LOAD SENSING SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Select the Data List using the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Brake Pedal Load Sensing SW | Brake pedal load sensing switch / ON or OFF | ON: Brake pedal depressed beyond a specified point OFF: Brake pedal not depressed beyond a specified point | - |
Check that the brake pedal load sensing switch display observed on the intelligent tester changes according to brake pedal operation.
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Perform a road test.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC C1429 is not output. | A |
| DTC C1429 is output. | B |
|
| ||||
| A | ||
| ||
| 3.INSPECT BRAKE PEDAL LOAD SENSING SWITCH |
![]() |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the brake pedal load sensing switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 2 (FSW+) - 1 (FSW-) | Switch OFF (Brake pedal depressed) | 950 to 1050 Ω |
| 2 (FSW+) - 1 (FSW-) | Switch ON (Brake pedal released) | 203 to 223 Ω |
| *a | Component without harness connected (Brake Pedal Load Sensing Switch (Brake Pedal Support Assembly)) |
| Result | Proceed to |
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
|
| ||||
|
| ||||
| A | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE PEDAL LOAD SENSING SWITCH) |
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A49-34 (FSW+) - A40-2 (FSW+) | Always | Below 1 Ω |
| A49-34 (FSW+) - Body ground | Always | 10 kΩ or higher |
| A40-1 (FSW-) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||