DTC P0013 Camshaft Position "B" Actuator Circuit / Open (Bank 1) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0013 | Open or short in camshaft timing oil control valve assembly (for exhaust camshaft) circuit (1 trip detection logic). |
|
| Related DTCs | P0013: Exhaust camshaft timing oil control valve assembly range check |
| Required Sensors/Components (Main) | Exhaust camshaft timing oil control valve assembly |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 1 second |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | - |
| Starter | Off |
| Ignition switch | ON |
| Time after ignition switch off to ON | 0.5 seconds or more |
| One of the following conditions is met | A, B or C |
| A. All of the following conditions are met | - |
| Battery voltage | 11 V or higher, and less than 13 V |
| Target duty cycle | Less than 70% |
| Output duty cycle | 100% or higher |
| B. All of the following conditions are met | - |
| Battery voltage | 13 V or higher |
| Target duty ratio | Less than 80% |
| Output duty cycle | 100% or higher |
| C. Both of the following conditions are met | - |
| Current cut status | Not cut |
| Output duty cycle | 3% or less |
| Output duty cycle | Higher than 3%, and less than 100% |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ OUTPUT DTC (DTC P0013) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTC after recording the freeze frame data and DTC.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON and wait 5 seconds.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0013 is output | A |
| DTC is not output | B |
|
| ||||
| A | |
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (FOR EXHAUST CAMSHAFT) |
Inspect the camshaft timing oil control valve assembly (for exhaust camshaft) (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY - ECM) |
Disconnect the camshaft timing oil control valve assembly (for exhaust camshaft) connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E56-1 (+) - E26-65 (OE1+) | Always | Below 1 Ω |
| E56-2 (-) - E26-64 (OE1-) | Always | Below 1 Ω |
| E56-1 (+) or E26-65 (OE1+) - Body ground | Always | 10 kΩ or higher |
| E56-2 (-) or E26-64 (OE1-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||