OCCUPANT CLASSIFICATION SYSTEM > Trouble in Passenger Airbag ON/OFF Indicator |
| Front Passenger Seat Condition | Passenger Airbag ON/OFF Indicator | SRS Warning Light | |
| ON Indicator | OFF Indicator | ||
| Vacant | OFF | OFF | OFF |
| Adult is seated. | ON | OFF | OFF |
| Child is seated. | OFF | ON | OFF |
| Child restraint system is installed. | |||
| Occupant classification system failure | OFF | ON | ON |
| 1.CHECK SRS WARNING LIGHT |
Turn the ignition switch to ON, and check the SRS warning light condition.
| Result | Proceed to |
| OK | A |
| NG (for Separate Type Yaw Rate Sensor) | B |
| NG (for Built-in Type Yaw Rate Sensor) | C |
|
| ||||
|
| ||||
| A | |
| 2.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Using the Techstream, perform Zero Point Calibration and Sensitivity Check (Click here).
|
| ||||
| OK | ||
| ||
| 3.RETIGHTEN FRONT SEAT ASSEMBLY RH BOLT |
Loosen the 4 installation bolts of the front seat assembly RH.
Tighten the 4 installation bolts of the front seat assembly RH to the specified torque (Click here for TMMK Made Manual Seat, Click here for TMMK Made Power Seat, Click here for SIA Made Manual Seat, Click here for SIA Made Power Seat).
| NEXT | |
| 4.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Using the Techstream, perform Zero Point Calibration and Sensitivity Check (Click here).
|
| ||||
| OK | ||
| ||
| 5.READ VALUE USING TECHSTREAM |
Using the Techstream, read Data List (Click here).
Read the display when the passenger side buckle switch is operated.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Passenger Buckle SW | Passenger side buckle switch/ Set: The seat belt is fastened Unset: The seat belt is not fastened NG: Data is not determined | Set/Unset | - |
|
| ||||
| OK | |
| 6.CHECK CONNECTORS |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the connectors from the occupant detection ECU and 2 rear occupant classification sensors.
Check that the terminals of the connectors are not damaged.
|
| ||||
| OK | |
| 7.REPLACE OCCUPANT DETECTION ECU |
Connect the connectors to the 2 rear occupant classification sensors.
Replace the occupant detection ECU (Click here).
Connect the cable to the negative (-) battery terminal.
| NEXT | |
| 8.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Using the Techstream, perform Zero Point Calibration and Sensitivity Check (Click here).
| NEXT | ||
| ||
| 9.CHECK CONNECTORS |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the connectors from the occupant detection ECU and front seat inner belt assembly RH.
Check that the terminals of the connectors are not damaged.
|
| ||||
| OK | |
| 10.REPLACE FRONT SEAT INNER BELT ASSEMBLY RH |
Connect the connector to the occupant detection ECU.
Replace the front seat inner belt assembly RH (Click here for Manual Seat, Click here for Power Seat).
Connect the cable to the negative (-) battery terminal.
| NEXT | |
| 11.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Using the Techstream, perform Zero Point Calibration perform Zero Point Calibration and Sensitivity Check (Click here).
| NEXT | ||
| ||