Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for 2GR-FE)

POWER STEERING SYSTEM (for 2GR-FE) > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


HINT:
If any DTCs are displayed during the DTC check, inspect the circuit listed for those DTCs. For details of each DTC, refer to the page indicated in the DTC chart.


Power Steering System 
DTC Code
Detection Item
Return-to-normal Condition
P/S Warning Light
See page
C1511
Torque Sensor Circuit Malfunction
Engine switch on (IG) again
*1
Click here
C1512
Torque Sensor Circuit Malfunction
Engine switch on (IG) again
*1
Click here
C1513
Torque Sensor Circuit Malfunction
Engine switch on (IG) again
*1
Click here
C1514
Torque Sensor Power Supply Abnormal
Engine switch on (IG) again
*1
Click here
C1521
Motor Circuit Malfunction
Engine switch on (IG) again
*1
Click here
C1524
Motor Circuit Malfunction
Engine switch on (IG) again
*1
Click here
C1528
Motor Rotation Angle Sensor Malfunction
Engine switch on (IG) again
*1
Click here
C1531
ECU Malfunction
Engine switch on (IG) again
*1
Click here
C1532
ECU Malfunction
Engine switch on (IG) again
*1
Click here
C1533
ECU Malfunction
After normal judgment
*2
Click here
C1534
ECU Malfunction
After normal judgment
*3
Click here
C1541
Vehicle Speed Signal Malfunction
Engine switch on (IG) again
*1
Click here
C1551
IG Power Supply Voltage Malfunction
Engine switch on (IG) again or after normal confirmation
*1
Click here
C1552
PIG Power Supply Voltage Malfunction
Engine switch on (IG) again or after normal confirmation
*1
Click here
C1554
Power Supply Relay Failure
Engine switch on (IG) again
*1
Click here
C1555
Motor Relay Welding Failure
Engine switch on (IG) again
*1
Click here
C1581
Assist Map Number Un-Writing
Assist map written
*1
Click here
C1582
Assist Map Number Mismatch
Engine switch on (IG) again
*2
Click here
U0100
Lost Communication with ECM / PCM "A"
After normal confirmation
*4
Click here
U0129
Lost Communication with Brake System Control Module
After normal confirmation
*1
Click here

HINT:
  1. *1: Warning light comes on
  2. *2: Warning light turns off
  3. *3: Torque and motor rotation angle sensor adjustment is set to the default value and control is continued. In this case, the warning light illuminates.
  4. *4: When an error occurs during steering assist, the warning light does not illuminate. For errors that occur before assist (at the time of the decision to start assist), the warning light illuminates.