53630
1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
Pass the hood lock control cable assembly into the engine compartment.
Pass the cable through the upper radiator support.
Engage the hood cable grommet.
Engage the 5 clamps and install the hood lock control cable assembly.
53630
2.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
Pass the hood lock control cable assembly into the engine compartment.
Pass the cable through the upper radiator support.
Engage the hood cable grommet.
Engage the 4 clamps and install the hood lock control cable assembly.
53510
3.INSTALL HOOD LOCK ASSEMBLY (for LHD)
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable assembly.
Install the hood lock assembly with the 2 bolts and hood lock bolt.
The hood lock nut cap is a non-reusable part. Be sure to install it after performing the Inspect Hood Sub-assembly and Adjust Hood Sub-assembly steps.
Connect the connector.
53510
4.INSTALL HOOD LOCK ASSEMBLY (for RHD)
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable assembly.
Install the hood lock assembly with the 2 bolts and hood lock bolt.
The hood lock nut cap is a non-reusable part. Be sure to install it after performing the Inspect Hood Sub-assembly and Adjust Hood Sub-assembly steps.
Connect the connector.
53601
5.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.
53601
6.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
62112A
7.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)
67914
8.INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)
62111A
9.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
67913
10.INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
53876A
11.INSTALL FRONT FENDER LINER LH (for LHD)
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>INSTALLATION
12.INSTALL FRONT WHEEL LH (for LHD)
53875A
13.INSTALL FRONT FENDER LINER RH (for RHD)
53851Z
14.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)
15.INSTALL FRONT WHEEL RH (for RHD)
16.INSTALL FRONT BUMPER ASSEMBLY
53301
17.ADJUST HOOD SUB-ASSEMBLY