| C1511/11
|
Torque Sensor 1 Malfunction
|
Torque sensor malfunction
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1512/11
|
Torque Sensor 2 Malfunction
|
Torque sensor malfunction
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1513/11
|
Torque Sensor Deviation Excessive
|
Torque sensor malfunction
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1514/11
|
Torque Sensor Power Supply Voltage Malfunction
|
Torque sensor malfunction
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1521/25
|
Short in Motor Circuit
|
Motor overcurrent
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1524/24
|
Motor Circuit Malfunction
|
Short (or open) in motor circuit or abnormal voltage or current in motor circuit
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1528/12
|
Motor Rotation Angle Sensor Malfunction
|
Motor rotation angle sensor malfunction
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1531/25
|
ECU Malfunction
|
ECU internal malfunction (CPU malfunction)
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1532/25
|
ECU Malfunction
|
ECU internal malfunction (Peripheral circuit malfunction)
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1533/25
|
Temperature Sensor Circuit is Low or High
|
ECU internal malfunction (Substrate temperature sensor malfunction)
|
EPS Warning Light: Does not come on
|
After normal judgment
|
|
| C1534/25
|
EEPROM Malfunction
|
ECU internal malfunction (EEPROM error)
|
EPS Warning Light: Torque and motor rotation angle sensor adjustment is set to the default value and control is continued. In this case, the warning light illuminates.
|
After normal judgment
|
|
| C1541/13
|
Vehicle Speed Signal
|
This DTC is detected when vehicle speed signals via CAN communication are cut off for 3 seconds or more.
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1551/25
|
IG Power Supply Voltage Malfunction
|
IG power source circuit malfunction inside ECU
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1552/22
|
PIG Power Supply Voltage Malfunction
|
PIG power source circuit malfunction inside ECU
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1554/23
|
Power Supply Relay Failure
|
Power source relay circuit malfunction
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1555/25
|
Motor Relay Welding Failure
|
Motor relay circuit malfunction
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
|
| C1581/26
|
Assist Map Number Un-Writing
|
Assist map not written in power steering ECU assembly
|
EPS Warning Light: Comes on
|
Assist map written
|
|
| C1582/26
|
Assist Map Number Mismatch
|
Assist map number mismatch
|
EPS Warning Light: Does not come on
|
Assist map written
|
|
| U0100/41
|
Lost Communication with ECM/PCM "A"
|
Lost communication with ECM
|
EPS Warning Light: When an error occurs during steering assist, the warning light does not illuminate. For errors that occur before assist (at the time of the decision to start assist), the warning light illuminates.
|
After normal confirmation
|
|
| U0129/42
|
Lost Communication with Brake System Control Module
|
Lost communication with brake actuator assembly
|
EPS Warning Light: Comes on
|
After normal confirmation
|
|