| Heavy steering
|
Front tires (improperly inflated, unevenly worn)
|
|
| Front wheel alignment (incorrect)
|
|
| Front suspension (lower ball joint)
|
|
| Electric power steering column sub-assembly
|
|
| Torque sensor (built into electric power steering column sub-assembly)
|
-
|
| Power steering motor assembly
|
-
|
| Speed sensor circuit
|
|
| Battery and power source system
|
-
|
| Power steering ECU assembly power source voltage and relay
|
|
| Power steering ECU assembly
|
|
| Steering effort differs between turning right and left, or steering effort is uneven.
|
Front tires (improperly inflated, unevenly worn)
|
|
| Front wheel alignment (incorrect)
|
|
| Front suspension (lower ball joint)
|
|
| Steering gear assembly
|
|
| Torque sensor (built into electric power steering column sub-assembly)
|
-
|
| Electric power steering column sub-assembly
|
|
| Power steering motor assembly
|
-
|
| Power steering ECU assembly
|
|
| While driving, steering effort does not change in accordance with vehicle speed or the steering wheel does not return properly.
|
Front suspension (lower ball joint)
|
|
| Speed sensor circuit
|
|
| Torque sensor (built into electric power steering column sub-assembly)
|
-
|
| Power steering motor assembly
|
-
|
| Power steering ECU assembly
|
|
| CAN communication system
|
|
| A knocking (or clunking) sound occurs when turning the steering wheel back and forth while power steering is operating.
|
Front suspension (lower ball joint)
|
|
| Steering intermediate shaft
|
-
|
| Power steering ECU assembly
|
|
| Noise occurs when turning the steering wheel during low-speed driving.
|
Steering gear assembly
|
|
| Electric power steering column sub-assembly
|
|
| Friction occurs when turning the steering wheel during low-speed driving.
|
Power steering motor assembly
|
-
|
| Electric power steering column sub-assembly
|
|
| A high-pitched sound (squeaking) occurs when turning the steering wheel slowly with the vehicle stopped.
|
Power steering motor assembly
|
-
|
| The steering wheel vibrates and noise occurs when turning the steering wheel from lock to lock with the vehicle stopped.
|
Steering gear assembly
|
|
| Electric power steering column sub-assembly
|
|
| DTCs cannot be output (Terminals TC and CG of the DLC3 are connected)
|
TC and CG terminal circuit
|
|
| IG power source circuit
|
|
| Combination meter assembly
|
|
| Signal check cannot be performed (terminals TS and CG of the DLC3 are connected)
|
TS and CG terminal circuit
|
|
| Power steering ECU assembly
|
|
| EPS warning light remains on.
|
EPS warning light circuit
|
|