Home › Engine / Hybrid System › 2AR-FXE FUEL › FUEL INJECTOR
RM2040EQ _51 Engine / Hybrid System _014694 2AR-FXE FUEL _0074910 FUEL INJECTOR A

2AR-FXE FUEL  FUEL INJECTOR  INSTALLATION  


PROCEDURE

Hide 23250 1.INSTALL FUEL INJECTOR ASSEMBLY

a.
A196010C04
2.49,1.781 2.667,1.781 2.667,1.781 3.104,1.365 false 2.344,1.708 2.51,1.906 0.167,0.198 10 *1
*1 O-ring


Apply a light coat of gasoline or spindle oil to new O-rings, and then install one onto each fuel injector.


b.

Apply a light coat of gasoline or spindle oil to the contact surfaces of the new O-ring on each fuel injector assembly.


c.
A284012

While turning the fuel injector assembly left and right, install it onto the fuel delivery pipe sub-assembly.

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing the injector.

Click hereEngine / Hybrid System>2AR-FXE FUEL>FUEL SYSTEM>PRECAUTION


HINT:

Perform "Inspection After Repair" after replacing the fuel injector assembly.

Click hereEngine / Hybrid System>2AR-FXE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



d.

Check that the fuel injector rotates smoothly. If the fuel injector does not rotate, replace the O-ring.


Hide 23814B 2.INSTALL FUEL DELIVERY PIPE

a.
A259323C01
2.177,0.635 2.385,0.635 false 2.417,0.542 2.583,0.698 0.167,0.156 10 false *1 1.469,1.021 1.635,1.177 0.167,0.156 10 false *b 1.469,0.146 1.635,0.302 0.167,0.156 10 false *a
*1 Fuel Delivery Spacer
*a Fuel Delivery Pipe Side
*b Cylinder Head Side


Install 4 new injector vibration insulators to the cylinder head.


b.

Install the 2 fuel delivery spacers onto the cylinder head.

HINT:

Install the fuel delivery spacer so that the longer protrusion is on the cylinder head side.



c.
A259301

Install the fuel delivery pipe with the 4 fuel injector assemblies and install the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:
·

Do not drop the fuel injectors when installing the fuel delivery pipe.

·

Check that the fuel injector assemblies rotate smoothly after installing the fuel delivery pipe.




d.

Connect the 4 fuel injector connectors.


Hide 23901 3.CONNECT FUEL TUBE SUB-ASSEMBLY

a.
A259317

Push the tube connector onto the pipe until the tube connector makes a "click" sound.

NOTICE:
·

Before connecting the fuel tube connector and fuel pipe, check that there is no damage or foreign matter on the connecting part of the fuel pipe.

·

After connecting the fuel tube connector and fuel pipe, check that they are securely connected by trying to pull them apart.




b.

Install the No. 1 fuel pipe clamp.


Hide 5.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64718C 6.INSTALL LUGGAGE TRIM SERVICE HOLE COVER