Home › Engine / Hybrid System › 2AR-FXE COOLING › RADIATOR › 2012.02–2015.04
RM2040EQ _51 Engine / Hybrid System _014697 2AR-FXE COOLING _0074934 RADIATOR A

2AR-FXE COOLING  RADIATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 53851Z 3.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 53852K 4.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 51441C 5.REMOVE ENGINE UNDER COVER RH

Hide 51442C 6.REMOVE ENGINE UNDER COVER LH

Hide 64718C 7.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 8.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53295E 9.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 10.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 53111 11.REMOVE RADIATOR GRILLE SUB-ASSEMBLY

Hide 16470 13.REMOVE RADIATOR RESERVE TANK ASSEMBLY

a.
A259362

Disconnect the radiator reserve tank hose.


b.

Remove the 2 bolts and radiator reserve tank assembly.


Hide 16571C 14.DISCONNECT NO. 1 RADIATOR HOSE

a.
A259363

Disconnect the No. 1 radiator hose.


Hide 16572D 15.DISCONNECT NO. 2 RADIATOR HOSE

a.
A255304

Disconnect the No. 2 radiator hose and clamp.


Hide G9170 16.DISCONNECT NO. 1 INVERTER COOLING PIPE ASSEMBLY

a.
A260430

Remove the 2 bolts and disconnect the No. 1 inverter cooling pipe assembly.


Hide 53510 17.REMOVE HOOD LOCK ASSEMBLY

Hide 53216A 18.REMOVE UPPER RADIATOR SUPPORT

a.
A279482

Disconnect the connector.


b.
A279483

Disconnect the hood lock control cable clamp and remove the 5 bolts and upper radiator support.


c.

Remove the 2 radiator support cushions.


Hide 16400 19.REMOVE RADIATOR ASSEMBLY

a.
A260429

Disconnect the 2 clamps.


b.
A259365

Disconnect the 2 clamps and connector.


c.
A262954

Disconnect the clamp and No. 4 inverter cooling hose.


d.
A262955

Remove the 4 bolts and separate the condenser assembly from the radiator assembly (for inverter coolant).


e.
A262956

Remove the radiator assembly with the fan assembly.

NOTICE:

Do not apply any excessive force to the radiator assembly (for inverter coolant), cooler condenser assembly or pipe when removing the radiator assembly.



f.

Remove the 2 lower radiator supports.


g.
A259368

Release the 3 claws and lift the fan assembly from the radiator.