Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM2040EQ _52 Drivetrain _014703 AXLE AND DIFFERENTIAL _0074961 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 3.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 4.DISABLE BRAKE CONTROL

Hide 5.REMOVE REAR WHEEL

Hide 6.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42491 7.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 42431 8.REMOVE REAR DISC

Hide 89516D 9.DISCONNECT SKID CONTROL SENSOR WIRE

Hide 42450B 10.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

a.
C240559

Remove the 4 bolts and the rear axle hub and bearing assembly.

NOTICE:

Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.