Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2040EQ _55 Steering _014713 POWER ASSIST SYSTEMS _0074999 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1581/26  Assist Map Number Un-Writing  


DESCRIPTION

This DTC will be stored if the power steering ECU assembly determines that the assist map is not written in the ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition
C1581/26 Assist Map Number Un-Writing Assist map not written in power steering ECU assembly
·

CAN communication system

·

Hybrid control system

·

Brake control system

·

Main body ECU (multiplex network body ECU)

·

Power steering ECU assembly


EPS Warning Light: Comes on Assist map written

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION


PROCEDURE

1.PERFORM ASSIST MAP WRITING
a.

Perform the assist map writing.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION

Chassis > EMPS > Utility
Tester Display
Signal Check
50005 142 3

b.

Check for DTCs.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

Chassis > EMPS > Trouble Codes
50001 142
Result:
Result Proceed to
DTC C1581/26 is output. A
DTC C1581/26 is not output. B


NOTICE:

DTC C1581/26 is cleared after the assist map is written.




A

2.CHECK CAN COMMUNICATION SYSTEM

B

END

2.CHECK CAN COMMUNICATION SYSTEM

Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

3.CHECK RELATED PART (POWER MANAGEMENT CONTROL ECU, MAIN BODY ECU AND SKID CONTROL ECU)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

3.CHECK RELATED PART (POWER MANAGEMENT CONTROL ECU, MAIN BODY ECU AND SKID CONTROL ECU)
a.

Check if any of the parts listed below have been replaced with an incorrect part in the past.

Related Part Power management control ECU
Main body ECU (multiplex network body ECU)
Brake booster with master cylinder assembly (skid control ECU)

NOTICE:
When removing a related part to check it, be sure to follow the appropriate procedures and precautions.
·

Refer to the following procedures to remove the power management control ECU.

Click herePower Source / Network>POWER DISTRIBUTION>POWER MANAGEMENT CONTROL ECU>REMOVAL

·

Refer to the following procedures to remove the main body ECU (multiplex network body ECU).

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL

·

Refer to the following procedures to remove the brake booster with master cylinder assembly (skid control ECU).

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER>REMOVAL



HINT:
·

DTC C1581/26 is stored when a part with an incorrect part number is installed for the related parts listed above.

·

When DTC C1581/26 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.




Result:
Result Proceed to
All installed related parts have correct part number A
Part with incorrect part number is installed B



A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE RELATED PART WITH RART THAT HAS CORRECT PART NUMBER