1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
53922B
4.REMOVE FRONT PANEL GARNISH LH
67914
5.REMOVE FRONT DOOR SCUFF PLATE LH
Use the same procedure as for the RH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62112A
6.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Use the same procedure as for the RH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62312B
7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
55318C
8.REMOVE INSTRUMENT SIDE PANEL LH
55607
9.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55303B
10.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
88150A
11.REMOVE DRIVING SUPPORT ECU ASSEMBLY
| *a | Clamp |
| *b | Guide |
Remove the nut.
Disengage the guide
Disengage the clamp.
Disconnect the connector to remove the driving support ECU assembly.