1. PRECAUTION (for 10 Speakers)
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
62311B
2.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
62211
3.REMOVE FRONT PILLAR GARNISH
55409F
4.REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
86160P
5.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY
Remove the 2 screws.
Lift the front No. 2 speaker assembly and disconnect the connector to remove the speaker.
Do not touch the speaker cone.
64718C
6.REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for 10 Speakers)
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for 10 Speakers)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE
8.REMOVE REAR CONSOLE BOX ASSEMBLY (for 10 Speakers)
58916
9.REMOVE BOX BOTTOM MAT (for 10 Speakers)
58804A
10.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for 10 Speakers)
11.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for 10 Speakers)
55660
12.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for 10 Speakers)
13.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for 10 Speakers)
55510F
14.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY (for 10 Speakers)
86160J
15.REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers)
Remove the 2 screws.
Lift the front No. 3 speaker assembly and disconnect the connector to remove the speaker.
Do not touch the speaker cone.