Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY › from 2015.04
RM2040EQ _58 Vehicle Interior _014727 SUPPLEMENTAL RESTRAINT SYSTEMS _0075088 KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67913 4.REMOVE FRONT DOOR SCUFF PLATE RH

Hide 62111A 5.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

Hide 62311B 6.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 55317A 7.REMOVE INSTRUMENT SIDE PANEL RH

Hide 53601 8.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 9.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 73900 10.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

CAUTION:

When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.


a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B286426

Remove the 4 bolts.


d.

Disengage the 2 claws to disconnect the DLC3.


e.

Disengage the 2 hooks to remove the lower No. 1 instrument panel airbag assembly.

NOTICE:

When removing the lower No. 1 instrument panel airbag assembly, do not pull the airbag wire harness.



f.
B296278C01
1.396,0.583 1.813,0.583 1.813,0.583 2.01,0.781 true 2.208,2.24 2.333,2.24 2.333,2.24 2.552,2.458 true 1.771,0.885 1.073,0.885 true 1.198,0.5 1.406,0.677 0.208,0.177 10 false *1 0.885,0.813 1.146,0.99 0.26,0.177 10 true *2 2.031,2.156 2.229,2.375 0.198,0.219 10 false *3
*1 Protective Tape
*2 Airbag Connector
*3 Airbag Connector Lock


Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.


g.

Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.