POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows) > Rear Power Window LH does not Operate with Rear Power Window Switch LH |

| 1.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR LH DOOR) - BATTERY) |
Disconnect the M7 rear power window regulator switch assembly (for LH door) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M7-2 (B) - Body ground | Engine switch on (IG) | 11 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR LH DOOR) |
Remove the rear power window regulator switch assembly (for LH door) (Click here).
Inspect the rear power window regulator switch assembly (for LH door) (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR LH DOOR) - POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR)) |
Disconnect the M6 power window regulator motor assembly (for rear LH door) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M7-7 (U) - M6-1 (U) | Always | Below 1 Ω |
| M7-7 (U) or M6-1 (U) - Body ground | Always | 10 kΩ or higher |
| M7-1 (D) - M6-2 (D) | Always | Below 1 Ω |
| M7-1 (D) or M6-2 (D) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
Remove the power window regulator master switch assembly (Click here).
Inspect the power window regulator master switch assembly (Click here).
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR LH DOOR)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K15-12 (RLU) - M7-3 (SU) | Always | Below 1 Ω |
| K15-12 (RLU) or M7-3 (SU) - Body ground | Always | 10 kΩ or higher |
| K15-15 (RLD) - M7-4 (SD) | Always | Below 1 Ω |
| K15-15 (RLD) or M7-4 (SD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||