Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows) > PRECAUTION

for Preparation Click here



1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.

System Name
See Procedure
Parking Assist Monitor System
Click here


2.POWER WINDOW CONTROL SYSTEM PRECAUTIONS

NOTICE:
  1. The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly (Click here).
  2. The power window control system prohibits the auto up and down function when the jam protection function malfunctions.
  3. If the power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door) has been replaced with a new one, initialize the power window control system (Click here).
  4. If the power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door) and door window regulator sub-assembly have been removed and installed, or if the power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door) was reused when a door glass or door glass run was replaced, initialize the power window control system (Click here).
  5. The jam protection function may operate unexpectedly, even when the power window control system is normal, due to detection of a value different than the operation learned value when the door glass moving speed changes sharply under any of the following conditions:
    1. A power window is being opened or closed while the vehicle is driven on a rough road.
    2. A power window is being opened or closed while the door is being opened or closed.
    3. The voltage changes abruptly.
  6. Do not disconnect the battery while the engine switch is on (IG). Otherwise, DTC B2313 will be stored (Click here).