FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) > Power Seat does not Return to Memorized Position |

| 1.CHECK FRONT POWER SEAT CONTROL SYSTEM |
Check that each function of the power seat operates normally by using the switches on the power seat switch (Click here).
|
| ||||
| OK | |
| 2.CHECK SEAT POSITION MEMORY FUNCTION |
Store a seat position in memory and check that the buzzer sounds to indicate that a position has been stored (Click here).
|
| ||||
| OK | |
| 3.CHECK SEAT POSITION RESTORING FUNCTION |
Under each of the following conditions, check that the seat position restoring function operates by pressing the M1 switch or M2 switch (Click here).
| Result | Proceed to |
| Seat position restoring function does not operate at all. | A |
| Seat position restoring function does not operate when the condition is *1. | B |
| C |
|
| ||||
|
| ||||
| A | |
| 4.READ VALUE USING GTS (SEAT POSITION MEMORY) |
Store a seat position in memory for each of the M1 and M2 switches (Click here).
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body / Driver Seat / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Seat Memory No1 | Seat position memorized with M1 switch / Mem or Not Mem | Mem: Memorized Not Mem: Not memorized | - |
| Seat Memory No2 | Seat position memorized with M2 switch / Mem or Not Mem | Mem: Memorized Not Mem: Not memorized | - |
|
| ||||
| OK | |
| 5.REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY LH |
Replace the outer mirror control ECU assembly LH (Click here).
| NEXT | |
| 6.CHECK SEAT POSITION RESTORING FUNCTION |
Restore a memorized seat position (Click here).
Check that the buzzer sounds for 0.1 seconds and the seat automatically moves to the memorized position.
|
| ||||
| OK | ||
| ||
| 7.REPLACE FRONT POWER SEAT SWITCH LH (W/ MEMORY) |
Replace the front power seat switch LH (w/ Memory) (Click here).
| NEXT | |
| 8.CHECK SEAT POSITION RESTORING FUNCTION |
Store a seat position in memory (Click here).
Restore a memorized seat position (Click here).
Check that the buzzer sounds for 0.1 seconds and the seat automatically moves to the memorized position.
|
| ||||
| OK | ||
| ||
| 9.READ VALUE USING GTS (PARK (P) STATE) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body / Driver Seat / Data List.
Read the Data List according to the display on the GTS.
| Tester Connection | Measurement Item/Range | Normal Condition | Diagnostic Note |
| P Switch | Park state signal / ON or OFF | ON: Shift lever in P OFF: Shift lever in a position other than P | - |
|
| ||||
| OK | ||
| ||
| 10.READ VALUE USING GTS (DRIVER DOOR COURTESY SWITCH) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Connection | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Door Courtesy | Front door courtesy light switch assembly signal / OPEN or CLOSE | OPEN: Driver door open CLOSE: Driver door closed | - |
|
| ||||
| OK | ||
| ||